EasyManua.ls Logo

Smeg WHT710ECIT - User Manual

Smeg WHT710ECIT
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
2820525387_IT/ 19-11-18.(13:53)
WHT710ECIT
Numero del documento
Lavatrice
Manuale utente
Washing Machine
User’s Manual

Questions and Answers

  • J
    Jordan MeyerSep 23, 2025
    Why does my Smeg Washer laundry remains wet at the end of the programme?
    • A
      Aaron UnderwoodSep 23, 2025
      If laundry remains wet after the programme ends in your Smeg Washer, it may be due to excessive foam from using too much detergent. Use the recommended amount of detergent to avoid this issue.
  • M
    Mark EricksonAug 23, 2025
    What to do if my Smeg WHT710ECIT won't start after closing the door?
    • A
      Andrea WalkerAug 23, 2025
      If your Smeg Washer program doesn't start after closing the door, it might be because the Start / Pause / Cancel button wasn't pressed. Press the Start / Pause / Cancel button to begin the program.
  • C
    Christopher ChristensenAug 25, 2025
    What to do if the loading door of Smeg Washer cannot be opened?
    • K
      Katelyn PerezAug 26, 2025
      If the loading door of your Smeg Washer cannot be opened, it could be due to a few reasons: * The door lock may be activated because of the water level: Drain the water by running the Pump or Spin programme. * The machine is heating up the water or is in the spinning cycle: Wait until the programme completes. * The child lock is engaged: Wait a couple of minutes after the programme ends for the door lock to deactivate.
  • C
    Carol PowersAug 27, 2025
    Why does my Smeg WHT710ECIT Washer not switch to spinning step?
    • C
      Christopher WarrenAug 27, 2025
      Your Smeg Washer might not switch to the spinning step due to: * Unbalanced load: The automatic unbalanced load detection system may be activated. * Incomplete draining: Check the filter and drain hose to ensure water is completely drained. * Excessive foam: Too much detergent can activate the automatic foam absorption system. Use the recommended amount of detergent.
  • A
    Amy FloresAug 27, 2025
    Why does my Smeg WHT710ECIT vibrate or make noise?
    • S
      Shannon WrightAug 27, 2025
      Your Smeg Washer may vibrate or make noise due to several reasons: * The machine might be unbalanced: Adjust the feet to level it. * There might be a hard substance in the pump filter: Clean the pump filter. * Transportation safety bolts might not be removed: Remove these bolts. * The laundry quantity might be too little: Add more laundry. * The machine might be overloaded: Remove some laundry or distribute the load evenly. * The machine might be leaning on something: Ensure it's not.
  • S
    Sharon SmithSep 17, 2025
    Why is foam overflowing from the detergent drawer of my Smeg Washer?
    • L
      lhubbardSep 17, 2025
      If foam is overflowing from the detergent drawer of your Smeg Washer, it's likely because too much detergent was used. Mix 1 tablespoon of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer.
  • J
    Jane LopezSep 14, 2025
    Why is there too much foam forms in my Smeg WHT710ECIT Washer?
    • B
      blanchardamySep 14, 2025
      Excessive foam in your Smeg Washer can be due to: * Using improper detergents: Use detergents specifically for washing machines. * Using too much detergent: Use only the necessary amount. * Improper detergent storage: Store detergent in a closed, dry location. * Foaming laundry items: Use less detergent for meshed items like tulle. * Detergent in wrong compartment: Put the detergent in the correct compartment.
  • B
    bradfordallenSep 15, 2025
    Why my Smeg WHT710ECIT Washer it does not rinse well?
    • D
      Donna HintonSep 16, 2025
      If your Smeg Washer isn't rinsing well, it could be due to: * Inappropriate detergent: Use a detergent suitable for washing machines and your laundry, and store it properly. * Detergent in the wrong compartment: Put detergent in the correct compartment. * Clogged pump filter: Check the filter. * Folded drain hose: Check the drain hose.
  • K
    Keith LarsonSep 6, 2025
    Why is my Smeg Washer washing performance is poor and clothes smell unpleasantly?
    • J
      Jeremy VasquezSep 6, 2025
      Unpleasant smells in your Smeg Washer can be caused by odours and bacteria forming due to continuous washing at low temperatures or in short programmes. To prevent this, leave the detergent drawer and loading door ajar after each wash to avoid a humid environment that encourages bacteria growth.
  • M
    Molly MedinaSep 3, 2025
    Why is there detergent residue in the detergent drawer of my Smeg WHT710ECIT?
    • M
      Malik JacksonSep 3, 2025
      Detergent residue in the drawer of your Smeg Washer can occur because: * The drawer was wet when you added detergent: Dry the drawer before adding detergent. * The detergent has gotten damp: Store detergents properly in a dry environment. * Low water pressure: Check the water pressure. * Blocked compartment holes: Check and clean the holes if they are clogged. * Detergent mixed with softener: Do not mix; wash and clean the dispenser with hot water.

Smeg WHT710ECIT Specifications

General IconGeneral
BrandSmeg
ModelWHT710ECIT
CategoryWasher
LanguageEnglish

Related product manuals