Smeg WHT714EUK - User Manual

Questions and Answers

J
Julia Pitts MDSep 8, 2025
Why does my Smeg Washer take so long to wash?
- B
  Brandy BurgessSep 8, 2025
  Several factors can cause your Smeg washer to take longer than usual. Low water pressure can cause the machine to wait until it has enough water, extending the wash time. Low voltage can also prolong the washing time to ensure good results. A low input water temperature means the machine needs more time to heat the water. Additionally, the number of rinses or the amount of rinse water may have increased. Excessive foam from too much detergent can also activate the automatic foam absorption system, adding to the wash time. To prevent this, use the recommended amount of detergent.
W
william62Aug 23, 2025
How to open a Smeg WHT714EUK door that is stuck?
- A
  amooreAug 23, 2025
  If the loading door of your Smeg washer cannot be opened, it may be due to a few reasons. The door lock could be activated because of the water level; drain the water by running the Pump or Spin program. The machine might be heating water or is in the spinning cycle, so wait until the program completes. Alternatively, the child lock might be engaged; wait a couple of minutes after the program ends for the door lock to deactivate.
P
powellnicholasAug 25, 2025
Why won't my Smeg Washer go to the spinning step?
- W
  William HicksAug 25, 2025
  If your Smeg washer isn't switching to the spinning step, there might be an unbalanced load in the machine, triggering the automatic unbalanced load detection system. Also, the machine won't spin if the water hasn't drained completely, so check the filter and drain hose. Excessive foam from too much detergent could also be the cause; use the recommended amount of detergent.
S
shahchadAug 27, 2025
How to start Smeg WHT714EUK Washer after closing the door?
- R
  Robin RichardsAug 27, 2025
  If the program on your Smeg washer doesn't start after closing the door, it may be because the Start / Pause / Cancel button was not pressed. Press the Start / Pause / Cancel button.
B
Brian GreeneAug 27, 2025
Why is my Smeg WHT714EUK not filling with water?
- A
  Angel BernardAug 28, 2025
  If your Smeg washer isn't filling with water, start by checking if the tap is turned on. Next, ensure the water inlet hose isn't bent. Also, the water inlet filter might be clogged, so clean it. Finally, make sure the loading door is completely closed.
L
Lauren LaraSep 22, 2025
What to do if the Smeg WHT714EUK programme cannot be started?
- T
  Tina JonesSep 22, 2025
  If a programme cannot be started or selected on your Smeg washing machine, it may have switched to self-protection mode due to a supply problem such as line voltage or water pressure. To resolve this, press and hold the On/Off button for 3 seconds.
C
Crystal Cisneros DDSSep 16, 2025
Why did my Smeg WHT714EUK Washer stop soon after starting?
- E
  emily99Sep 16, 2025
  If your Smeg washer stopped shortly after the programme started, it might have paused temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
W
williamsstaceySep 18, 2025
Why does my Smeg WHT714EUK immediately discharge water?
- F
  Fernando WhiteheadSep 18, 2025
  If your Smeg washer immediately discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
A
Adam SullivanSep 7, 2025
Why is my Smeg WHT714EUK Washer vibrating or making noise?
- F
  feliciastephensSep 7, 2025
  If your Smeg washer is vibrating or making noise, it could be due to several reasons. First, ensure the machine is standing balanced by adjusting the feet. A hard substance might be in the pump filter, so clean it. Remove the transportation safety bolts if you haven't already. The laundry quantity might be too little or too much; adjust the load accordingly. Also, ensure the machine isn't leaning on anything.
C
christopher70Sep 4, 2025
Why do my clothes smell bad after washing in my Smeg WHT714EUK Washer?
- A
  Angela WheelerSep 4, 2025
  If your clothes smell unpleasant after washing in your Smeg washer, odors and bacteria layers may have formed on the drum due to continuous washing at lower temperatures or in short programmes. To prevent this, leave the detergent drawer and loading door ajar after each wash to discourage bacteria growth.