Use and maintenance manual FP560 - FP560A - FP870A
41
When the parameter is enabled (value ≠0):
- by setting the value at 0.5, the sealing frame descends as soon as the conveyor belt stops.
- by setting the value at >0.5, the descent time of the sealing frame is delayed from the moment
the conveyor belt stops.
Increasing the value, therefore, decreases the speed at which the sealing frame opens and
closes. The rate, at packs/minute, for wrapping at the configured settings, is displayed on the
operator panel.
5.7 ACCESS TO RESERVED MENU
Press and simultaneously to access the reserved menu with the adjustment
parameters calibrated when the machine was test inspected.
Use the password PROGR to access the selection of parameters normally adjusted at
machine inspection.
To enter the password, select the letters of the alphabet with the and ; keys; the
introduction of each character must be confirmed by pressing .
1 • Choosing display language
Menu for adjusting display language.
Fig. 5.6.5
X.X= packs/minute
Fig. 5.7.1
Fig. 5.7.2
Auto ppm X.
M1
Password *****
English 2
To Next Page
Loading...
