Use and maintenance manual FP560 - FP560A - FP870A
47
to be glued at the bottom of the conduit.
• Insert the new silicon rubber in line without pressing or pulling it.
• Apply the PTFE strip as indicated previously.
6.5 CHECKING THE LEVEL OF COOLANT
Periodically check that the level of coolant is between the minimum and maximum limits. If it is
too low, undo the cap (1) and top up with anti-freeze liquid.
Turn off the machine and wait for it to cool down beforehand.
6.6 ACCESS TO ELECTRICAL PANEL
If it is necessary to open the electrical panel of the machine, turn off and unplug the machine
and wait at least 5 minutes before doing the following:
• Move outwards the holding plate 1 without removing it to be able to easily unscrew the
screws 2 to open the protective support 3 of the electrical panel as shown in the figure.
To Next Page
Loading...
