Smithco 13-550-C - Page 67

65
Accessories
13-107 INFIELD SCARIFIER PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-117 Grader Blade 1
2 HCP-12-150 Clevis Pin
1
/2 x 1
1
/2 2
3 HHP-18 Bridge Pin
1
/8 3
4 13-115 Hitch (Pistols) 2
5 HMB-34-10 Machine Bushing
3
/4 x 10GA 12
6 HMB-12-14 Machine Bushing
1
/2 x 14GA 4
7 HP-18-100 Cotter Pin
1
/8 x 1 1
8 HB-38-16-100 Bolt
3
/8 - 16 x 1 9
9 13-114 Digger Blade 9
10 13-113 Frame 1
11 HNCL-38-16 Center Lock Nut
3
/8 - 16 9
12 HRP-14-100 Roll Pin
1
/4 x 1 2
13 Attachment Lift (part of Lift Assembly)
14 HB-716-14-150 Bolt
7
/16 - 14 x 1
1
/2 2
HNTL-716-14 Lock Nut
7
/16 -14 2
15 19-217 Transportation Hook 1
INSTALLATION INSTRUCTIONS
Optional Lift Assembly 13-505 must be installed before installing this unit on Super 2.
1. Slide the Transportation Hook over the right tube of the (Ref# 2) Frame. Insert (Ref# 12) Bridge Pin in hook
for use when required later.
2. Using nine (Ref# 10) Bolts and (Ref# 7) Nuts attach (Ref# 8) Digger Blades to (Ref# 2) Frame.
3. Insert (Ref# 13) Hitch (pistols) into tubes of Frame with up to five (Ref# 5) Machine Bushings in front and
one bushing in the rear of tube. Secure pistols with (Ref# 6) Roll Pins. Check spacing before driving in roll
pin all the way. For more tire clearance, machine bushings may be moved from front to rear.
4. Attach (Ref# 1)Grader Blade to (Ref# 2) Frame as shown using (Ref# 9) Machine Busing and (Ref# 11)
Cotter Pin.
5. Lift (Ref# 1 and 2) Grader Blade/Frame Unit and hook pockets over the arms of (Ref# 4) Attachment Lift.
6. Attach pistols to the tabs of the trap rake frame undercarriage in the rear holes using (Ref# 14) Clevis
Pins, (Ref# 12) Machine Bushings and (Ref# 14) Bridge Pins.
7. Turn machine on and test for proper operation.