Snap-On APOLLO D8 Quick Start Guide

Scanner
Previous Vehicle
and Data
Quick LookupsOBD-II/EOBD
Tools
Scanner
Pr
e
vi
ous
V
e
hi
c
l
e
and Dat
a
Q
uick Lookups
OBD-II/
EOBD
T
oo
l
s
4
5
Getting Started
This side up.
A
1. Remove the battery pack cover,
and install the battery pack
(as shown) with the arrows facing
up. Tilt the top of the battery in to
align the tabs, then down to install.
2. Install the battery pack cover,
aligning the tabs . Then tighten
the screws.
Note - Do not overtighten the screws.
4. Press the Power button.
Note - When you connect the Data Cable
to an OBD-II vehicle, the diagnostic tool is
powered by the vehicle.
6. To scan a vehicle:
a. Select Scanner.
b. Follow the screen prompts to ID
the vehicle and to connect the
Data Cable.
c. Select a test/service and follow
the screen prompts.
3. Connect the AC power supply, to
charge the battery.
3
Scanner
Previous Vehicle
and Data
Quick LookupsOBD-II/EOBD
Tools
Scanner
Pr
e
vi
ous
V
e
hi
c
l
e
a
n
d
D
a
t
a
Q
uick Lookups
OBD-II/
EOBD
T
oo
l
s
6
A
a. From the Home screen, select
Tools > Settings >
&RQ¿JXUH:L)L.
b. Select the Wi-Fi Power icon .
The icon will change to
indicating the Wi-Fi
radio is on.
c. Select a wireless network from
the list of available networks, then
select Connect.
***IMPORTANT***
Turn Wi-Fi on to use Intelligent
Diagnostics, Quick Lookups and
SureT
rack.
5. To turn on Wi-Fi:

Snap-On APOLLO D8 Specifications

General

Brand	Snap-On
Model	APOLLO D8
Category	Diagnostic Equipment
Language	English