Snap-On ControlTech Micro User Manual

13
3. UP/DOWN buttons are used to scroll screen.
Operational Information:
 SN: Serial number assigned to wrench.
 CAL: Date of last wrench calibration.
 ISD: In-Service Date.
 TCF: Torque Calibration Factor.
 ACF: Angle Calibration Factor.
 VER: Software version.
 OVR CNT: Overtorque Counter tracks how many times an over-torque event occurred on
wrench (torque >125% of full scale).
 TQZ: Torque Zero Offset.
 AZZ: Angle Z-Axis Zero Offset.
 AXZ: Angle X-axis Zero Offset.
 Copyright
4. Pressing ENTER button exits Show Info screen and returns to Settings menu.
Setting Sleep Time
This function will allow user to set interval wrench enters power-down state following last applied
torque or button press.
1. From Settings menu, use UP/DOWN buttons to highlight SLEEP TIME selection then press ENTER
button.
2. SLEEP TIME screen is displayed.
3. Use UP/DOWN buttons to select sleep interval.
Selectable Intervals:
 2 MIN (factory default)
 5 MIN
 10 MIN
 30 MIN
 1 HR
 2 HR
 8 HR
4. Press ENTER button to accept selection and exit to Settings menu.
EXIT
SHOW INFO
SLEEP TIME
SN: 0417500366
CAL: 2017/01/01
ISD: 2017/01/01
ENTER
button
UP/DOWN buttons
AXZ: 157
CAL: 2017/01/01
© 2017 SNAP-ON
ENTER
button
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button
EXIT
SHOW INFO
SLEEP TIME
EXIT
SHOW INFO
SLEEP TIME
SLEEP TIME
2 MIN
EXIT
SLEEP TIME
8 HR
EXIT

Snap-On ControlTech Micro Specifications

General

Brand	Snap-On
Model	ControlTech Micro
Category	Power Tool
Language	English