Snap-On ControlTech Micro User Manual

14
Setting LCD Contrast
This function will allow user to set LCD contrast for optimal viewing.
1. From Settings menu, use UP/DOWN buttons to highlight LCD CONTRAST selection then press
ENTER button.
2. CONTRAST screen is displayed.
3. Use UP/DOWN buttons while viewing display to change contrast to desired level.
Selectable levels: 20 to 80 in increments of 5 (factory default = 40).
4. Press ENTER button to accept selection and exit to Settings menu.
Key Beep Setup
This function will allow user to enable or disable audio feedback when a button is pressed.
1. From Settings menu, use UP/DOWN buttons to highlight KEY BEEP selection then press ENTER
button.
2. KEY BEEP screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE (factory default) or DISABLE selection.
4. Press ENTER button to accept selection and exit to Settings menu.
Auto Backlight Setup
This function will allow user to enable or disable backlight from turning on during torque or angle
measurement.
1. From Settings menu, use UP/DOWN buttons to highlight AUTO BACKLIGHT selection then press
ENTER button.
2. AUTO BACKLIGHT screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE (factory default) or DISABLE selection.
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button
EXIT
SHOW INFO
SLEEP TIME
SHOW INFO
SLEEP TIME
LCD CONTRAST
CONTRAST: 20
CONTRAST: 80
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button
EXIT
SHOW INFO
SLEEP TIME
SLEEP TIME
LCD CONTRAST
KEY BEEP
KEY BEEP
ENABLE
DISABLE
KEY BEEP
ENABLE
DISABLE

Snap-On ControlTech Micro Specifications

General

Brand	Snap-On
Model	ControlTech Micro
Category	Power Tool
Language	English