Snap-On ControlTech Micro User Manual

21
Note: If LOCK is selected without a Preset configured, following screen is displayed:
Note: When Preset Lock is enabled, Clear Memory function is disabled and displays following Locked
message if attempted:
Note: When Preset Lock is enabled, Clear Cycle count function is disabled and displays Locked message
if attempted.
Preset Unlock
When Preset Lock is enabled, a password is required to access Configure menu. Refer to ControlTech™
Micro Calibration Manual for Configure password.
1. From target torque or angle screen, press and hold ENTER button for 3 seconds.
2. Highlight CONFIGURE menu selection using UP/DOWN buttons.
3. Press ENTER button to display Password screen.
4. Follow password entry procedure found in ControlTech™ Micro Calibration manual.
Delete Presets
Delete Presets function allows user to delete all presets at once.
1. From Configure menu, use UP/DOWN buttons to highlight DELETE PRESET selection then press
ENTER button.
2. Delete Presets confirmation screen is displayed.
3. Use UP/DOWN buttons to select YES or NO selection.
4. Press ENTER button to accept selection and exit to Configure menu.
Note: If Delete Presets is selected without a Preset configured, following screen is displayed:
Job Mode
LOCKED
PRESS TO CONT.
NO PRESETS
PRESS TO
CONT.
NO PRESETS
PRESS TO CONT.
UP/DOWN buttons
ENTER
button
held
Preset Screen
ENTER
button
EXIT
SET HEAD LENGTH
SHOW DATA
LANGUAGE
SETTINGS
CONFIGURE
ENTER PASSWD
0 0 0 0 0
PSET 01 03
100.0 IN-LB
UP/DOWN buttons
ENTER
button
UP/DOWN buttons
Delete Presets menu
EXIT
MODE SETUP
PRESET LOCK
MODE SETUP
PRESET LOCK
DELETE PRESETS
DELETE PRESETS
YES
NO

Snap-On ControlTech Micro Specifications

General

Brand	Snap-On
Model	ControlTech Micro
Category	Power Tool
Language	English