Snap-On CT9050 - Functional Description; Specifications

7
ZCT9050CE Rev. C (01/25)
100-120 Volt
Charger
Cord Length (feet)
Wire Size (AWG)
25
50
100
18
18
18
220-240 Volt
Charger
Cord Length
(meters)
Wire Size (mm)
50
75
0.75
1.0
Recommended Extension Cord Length
SAVE THESE
INSTRUCTIONS
Functional Description
A
C
D
E
B
F
Figure 1: Cordless Impact Wrench
A. Friction Ring Anvil
B. Forward/Reverse Bar
C. Trigger
D. Release Button
E. Battery Pack
F. Power Settings
Specifications
Impact Wrench Specications
Square Drive Size
CT9050 ............. 1/2” (13mm) Friction Ring Anvil
CT9050P ....................1/2” (13mm) Pinned Anvil
CT9050L ....................1/2” (13mm) Friction Ring
3” (76mm) Long Anvil
CT9050LP ...........................1/2” (13mm) Pinned
3” (76mm) Long Anvil
CT9050XL ..................1/2” (13mm) Friction Ring
6” (152mm) Long Anvil
CTQ9050 .. ....................................Quick Change
7/16” Internal Hex Anvil
Tightening Torque
CT9050/CT9050P ...........800 ft. lbs. (1085 N•m)
CT9050L/CT9050LP .........650 ft. lbs. (880 N•m)
CT9050XL ...................... ... 500 ft.lbs (680 N•m)
CTQ9050 .. ......................... 400 ft.lbs (540 N•m)
Bolt Breakaway Torque
.......................................1000 ft.lbs (1355 N•m)
Free Speed ............................................ 2000 rpm
Impacts per Minute ................................2300 ipm
Motor Voltage ........................................18.0 VDC
Weight with Battery Pack (Lithium-Ion)
CT9050/CT9050P/CTQ9050 .......6.5 lbs. (2.9 kg)
CT9050L/CT9050LP ................ 6.8 lbs. (3.1 kg)
CT9050XL ..................................7.1 lbs. (3.2 kg)
Noise* (Tested in accordance with EN 62841)
Sound Pressure Level (A) .......................92.4 dB
Uncertainty, K ...........................................3.0 dB
Sound Power Level (A) .........................104.0 dB
Uncertainty, K ...........................................3.0 dB
Vibration* (Tested in accordance with EN 62841)
Vibration Level .....................................5.48 m/s
2
Uncertainty, K ......................................1.20 m/s
2
* NOTE: The declared vibration total value(s) and
the declared noise emission value(s) have been
measured in accordance with a standard test
method and may be used for comparing one tool
with another. The declared vibration total value(s)
and the declared noise emission value(s) may also
be used in a preliminary assessment of exposure.
The vibration and noise emissions during actual
use of the power tool can differ from the declared
values depending on the ways in which the tool is
used especially what kind of workpiece is
processed. Identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
Snap-on disclaims liability for the consequences of
using the declared values, instead of values
reflecting the actual exposure determined in an
individual risk assessment in a work place situation
over which we have no control.