Snap-On EEDM596F - Capacitance Measurement

EEDM596F
Advanced Digital Multimeter
With Color LCD and Bluetooth
®
EEDM596F-Z Rev.
B
(05/19)
12
Measuring Amps AC
Range: 0.00 – 10 Amps AC
CAUTION!
Do not attempt to make a current
measurement with the test leads connected
in parallel with circuit to be tested. Test
leads must be connected in series with the
circuit.
WARNING!
Do not attempt to make a current
measurement of circuits with more than
600V present. Instrument damage and/or
personal injury may result.
Rotary switch position
Selecting the AC mode
Press this button so the AC symbol is on the LCD.
Test lead connection
COM – Black Test Lead
A – Red Test Lead
Optional functions
Activates manual ranging. Hold in for 2 seconds
to return to auto range.
Activates the Min/Max/Ave Record mode.
Hold in for 2 seconds to deactivate.
Toggles between +/- trigger in IP or IG function.
Activates relative mode.
Hold in for 2 seconds to deactivate.
Activates Data Hold on non-automotive
functions. Press again to deactivate.
Hold down for 2 seconds to activate 1mS Peak
Hold on DC volt and DC current functions.
Measuring Capacitance
Range: 0.00 – 10 mF
CAUTION!
Disconnect power to the circuit(s) to be
measured. Discharge the capacitor
completely before attempting to measure.
Rotary switch position
Test lead connection
COM – Black Test Lead
VΩHz – Red Test Lead
Optional functions
Activates manual ranging. Hold in for 2 seconds
to return to auto range.
Activates the Min/Max/Ave Record mode.
Hold in for 2 seconds to deactivate.
Toggles between +/- trigger in IP or IG function.
Activates Data Hold on non-automotive
functions. Press again to deactivate.