Snap-On TECHANGLE - Sleep Time; Lcd Contrast

12
Setting Sleep Time
This function will allow user to set interval wrench enters power-down state following last applied
torque or button press.
1. From Settings menu, use UP   /DOWN   buttons to highlight SLEEP TIME selection then press
ENTER   button.
2. SLEEP TIME screen is displayed.
3. Use UP   /DOWN   buttons to select sleep interval.
Selectable Intervals:
 2 MIN (factory default)
 5 MIN
 10 MIN
 30 MIN
 1 HR
 2 HR
 8 HR
4. Press ENTER   button to accept selection and exit to Settings menu.
Setting LCD Contrast
This function will allow user to set LCD contrast for optimal viewing.
1. From Settings menu, use UP   /DOWN   buttons to highlight LCD CONTRAST selection then
press ENTER   button.
2. CONTRAST screen is displayed.
ENTER
button
CAL: 2013/01/01
ISD: 2013/01/01
TCF: 14800
ACF: 1257
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
ENTER
button
VER: 1.0
OVR CNT: 0
TQZ: -1539
ANZ: 8196
UP/DOWN buttons
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
ENTER
button
SLEEP TIME
2 MIN
EXIT
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
ENTER
button
UP/DOWN buttons
SLEEP TIME
8 HR
EXIT