Snap-On TECHANGLE - Data Management and Cycle Counter

7
3. In Show Data screen, scroll through each stored data record by pressing UP   /DOWN  
buttons.
Example: 02 = Show Data List Counter: TQ = Peak torque value
01 = Show Data List Counter: TQ = Peak torque value: ANG = Peak angle value
4. Pressing ENTER   button while on Show Data screen returns to main menu.
Note: A maximum of 50 data records can be stored in memory. Memory full icon will be displayed
when full. New data will replace oldest record until memory is cleared.
Deleting Stored Torque and Angle Data
1. From target torque or angle screen, press and hold ENTER   button for 3 seconds.
2. Highlight CLEAR DATA menu selection using UP   /DOWN   buttons then press ENTER  
button to display CLEAR ALL DATA screen.
3. In CLEAR ALL DATA screen, highlight YES menu selection to delete all stored data, or NO menu
selection to exit without deleting data.
4. Press ENTER   button after making selection.
Viewing and Clearing Wrench Cycle Counter
Each time torque or angle target is reached, wrench cycle counter is incremented. Maximum cycle
count is 999999.
1. From target torque or angle screen, press and hold ENTER   button for 3 seconds.
2. Highlight CYCLE COUNT menu selection using UP   /DOWN   buttons.
3. Press ENTER   button to display CYCLES screen.
4. To exit CYCLE COUNT screen without clearing count, press ENTER   button while EXIT menu
selection is highlighted.
5. To reset wrench cycle count to 0, highlight CLEAR menu selection then press ENTER   button.
6. EXIT menu selection is automatically highlighted after count is cleared. Press ENTER   button to
return to main menu.
00
M 100.0 FT-LB
02: 15:40:15
2013/06/26
TQ: 14.2 FT-LBS
M
EXIT
SET HEAD LENGTH
SHOW DATA
M CLEAR DATA
OR
UP/DOWN buttons
If clock has been
set data
timestamp will
be displayed
(see Advanced
Configuration).
01: 15:35:05
2013/03/26
TQ: 15.3 FT-LBS
M ANG 84 DEG
01:
TQ: 15.3 FT-LBS
M ANG 84 DEG
EXIT
SET HEAD LENGTH
SHOW DATA
M CLEAR DATA
02:
TQ: 14.2 FT-LBS
M
ENTER
button
held
Target Screen
ENTER
button
UP/DOWN buttons
OR
00
M 100.0 FT-LB
EXIT
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
EXIT
SET HEAD LENGTH
SHOW DATA
M CLEAR DATA
EXIT
SET HEAD LENGTH
SHOW DATA
M CLEAR DATA
CLEAR ALL DATA
YES
M NO
CLEAR ALL DATA
YES
M NO
EXIT
SET HEAD LENGTH
SHOW DATA
M CLEAR DATA
ENTER
button
held
Target Screen
ENTER
button
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button