Snap-On TECHANGLE - Advanced Configuration

15
Vibrator Configuration
This function will allow user to configure vibrator for On or Off when target is reached for preference
and/or battery power savings.
1. From Settings menu, use UP   /DOWN   buttons to highlight VIBRATOR CONFIG selection then
press ENTER   button.
2. VIBRATOR CONFIG screen is displayed.
3. Use UP   /DOWN   buttons to toggle ON or OFF selection.
4. Press ENTER   button to accept selection and exit to Settings menu.
 Advanced Configuration
Accessing Advanced Configuration
Advanced configuration is accessed from CONFIGURE menu selection on main menu.
1. From target torque or angle screen, press and hold ENTER   button for 3 seconds.
2. Highlight CONFIGURE menu selection using UP   /DOWN  buttons.
3. Press ENTER   button to display Configure menu.
Menu Selections:
 EXIT - Exits Configure menu and returns to target torque or angle screen.
 MODE SETUP - Displays wrench mode setup menu.
 CALIBRATION - Displays wrench calibration menu (password protected).
 SET DATE/TIME - Displays clock date and time entry screens.
 SET CAL INTRVAL - Displays calibration interval setup screen (requires clock date and time
setup).
4. To exit Configure menu and return to target torque or angle screen, press ENTER   button while
EXIT menu selection is highlighted.
00
100.0 FT-LB
Target Screen
CLEAR DATA
CYCLE COUNT
SETTINGS
CONFIGUREs
UP/DOWN buttons
EXIT
MODE SETUPs
CALIBRATION
SET DATE/TIME
EXIT
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
ENTER
button
held
ENTER
button
Configure menu
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
ENTER
button
VIBRATOR CONFIG
ON
EXIT
ENTER
button
UP/DOWN buttons
VIBRATOR CONFIG
OFF
EXIT
KEY BEEP
AUTO BACKLIGHT
TOGGLE BACKLGHT
VIBRATOR CONFIG