Snap-On TECHANGLE - User Instructions; Basic Operation and Power On

3
User Instructions
 Basic Functions (Quick Start)
Figure 1
Install three fresh "AA" cells into wrench handle.
Wrench Power On Sequence
Note: Do not turn on wrench while torque is applied, otherwise torque zero offset will be incorrect
and wrench will indicate a torque reading when torque is released. If this occurs, re-zero
wrench by momentarily pressing POWER q button while wrench is on a stable surface with no
torque applied.
1. Turn On Wrench.
Momentarily press POWER q button. Snap-on logo is displayed followed by torque re-
zeroing screen. If previous measurement was angle measurement, then angle re-zeroing
screen follows the torque zeroing screen. After re-zeroing, the target torque or target angle
screen is displayed depending on previous measurement mode.
2. Select Measurement Mode.
Toggle between target TORQUE and ANGLE screens by repeatedly pressing
ENTER   button.
MODE
COUNT
AUDIBLE ALERT
PROGRESS LIGHTS
Yellow - First light indicates 40% of target torque
or angle reached, Second indicates 60%
of target reached, Third indicates 80% of
target reached.
Green - Indicates target torque or angle reached.
Red - Indicates exceeded torque or angle
target+4% for targets above 20% to
100% of F.S. or target+10% for targets
from 5% to 20% of F.S, or exceeded
MAXIMUM Preset target (Note: Yellow
lights also turn on with red).
MODE SELECT, MENU ENTRY AND ENTER BUTTON
INCREMENT
BUTTON
ON/OFF
AND
RE-ZERO
BUTTON
DECREMENT
BUTTON
LCD BACKLIGHT
AND
PEAK TORQUE/ANGLE
RECALL BUTTON
UNITS AND
PRESET ENTRY
BUTTON
TORQUE AND/OR
ANGLE DISPLAY
BATTERY
CONDITION
PROGRESS
LIGHTS
PROGRESS
LIGHTS
DATA
STORAGE
ALERT
00
250.0 FT-LB
TORQUE ZEROING
ANGLE ZEROING
--
SET STILL
00
180 DEG
Target Angle Screen
ENTER
button
Target Torque Screen
ENTER
button
00
ANGLE ZERO REQ
180 DEG
POWER
button