106
M2 Scope/Meter M2 Scope/Meter Operations
Position Selections
The Position selections allow you to reposition the baselines of the channel 1 and channel 2 traces
vertically on the screen.
Figure 8-18 Sample screen with both traces repositioned
Channel 1 Trace
Use the F2 and Min/Max keys to reposition the channel 1 trace as follows:
• Short pushes of the F2 key moves the trace incrementally up.
• A long push of the F2 key places the trace at the midpoint of the scale.
• Short pushes of the Min/Max key moves the trace incrementally down.
• A long push of the Min/Max key places the trace at 10% of the scale.
Channel 2 Trace
Use the F3 and Range keys to reposition the channel 2 trace as follows:
• Short pushes of the F3 key moves the trace incrementally up.
• A long push of the F3 key places the trace at the midpoint of the scale.
• Short pushes of the Range key moves the trace incrementally down.
• A long push of the Range key places the trace at 10% of the scale.
' ' ' '
&+
'&
P6
7$872
7&+
9
9'LY
7
7$I
1PTJUJPO 7$I
To Next Page
Loading...
