Snap-On VERDICT - Cleaning and Inspecting the Diagnostic Tool

196
Maintenance Diagnostic Tool
z To calibrate the touch screen with the Diagnostic Tool installed in docking cradle:
1. With the Diagnostic Tool installed in the docking cradle, connect a USB keyboard and an
external monitor.
IMPORTANT:
The Intel Graphics Display Config should be set to “LVDS (extended) CRT”, refer to the
procedure above to verify or reset the configuration.
2. From the Windows toolbar select Start > PenMount Control Panel to open the dialog box.
3. From the dialog box, select the Multiple Monitors tab.
4. With the Multiple Monitor Support box checked, select the Map Touch Screens icon
(Figure 17-5).
Figure 17-5 Sample Multiple Monitors tab
5. Follow the screen prompts and touch the screen of the Diagnostic Tool as requested.
6. Type “S” on the USB keyboard to skip for extended display as requested.
7. Select OK from the Multiple Monitors tab to close the PenMount Control Panel dialog box.
8. Calibrate the touch screen using the standard procedure.
17.1.3 Cleaning and Inspecting the Diagnostic Tool
When using the VERDICT Diagnostic Tool, make sure to do the following:
• Check the housing, wiring, and connectors for dirt and damage before and after each use.
• At the end of each work day, wipe the VERDICT Diagnostic Tool housing, wiring, and
connectors clean with a damp cloth.
IMPORTANT:
Do not use any abrasive cleansers or automotive chemicals on the VERDICT Diagnostic Tool.