91
M2 Scope/Meter M2 Scope/Meter Operations
8.3 M2 Scope/Meter Operations
This section details the digital multi-meter (DMM) features available based on the Rotary Selector
Switch position.
8.3.1 Volts DC
The Volts DC setting is used for measuring direct current (DC) voltages within a range of zero to
1000 volts, frequency, duty cycle, and pulse width.
Figure 8-3 Volts DC selected
A typical Volts DC screen with Min/Max active is shown in Figure 8-4. Note the functions of the F1,
F2, and F3 soft keys are shown at the bottom of the display screen. The F4 soft key is not
operational in the Volts DC mode, although the beeper does sound if the key is pressed.
Figure 8-4 Sample Volts DC screen
'SFF[F3FMBUJWF 3BOHF
' ' ' '
7%$
3&- 3&'
77
To Next Page
Loading...
