128
Scope Multimeter Operations Operations
9.3.3 Scope and Multimeter Setup
The following sections explain how to adjust the scope and multimeter for the specific type of
signal being sampled. Most of these setup operations are available from the toolbar.
Trace Controls
The Traces controls are used to adjust individual characteristics of how the signal is sampled and
displayed for each trace. The more commonly used trace settings can also be made from the
Trace Details area of the touch screen (see Trace Details on page 122). Trace Details offers a
shortcut to some of the operations described in the following sections.
z To adjust trace controls:
1. Select Setup from the Scope Multimeter toolbar.
The Scope Multimeter Preferences dialog box opens.
2. Double tap Traces to open the submenu.
3. Select the tab for the trace to be configured from the submenu
The traces dialog box displays (Figure 9-11).
1— Trace tabs
2— Trace Probe icon
3— Trace Scale icon
4— Trace characteristics check boxes
5— Auto Find icon
6— Baseline position
7— Back icon
8— Exit icon
Figure 9-11 Traces dialog box
To Next Page
Loading...
