116
Scope Multimeter Operations Getting Started
9.1.2 Leads and Adapters
The Scope Multimeter uses standard safety banana plugs that are compatible with many
accessories. The various leads, clips, and adapters that are supplied with or available for the
VERDICT M2 unit explained in this section.
When removing leads from their sockets, do not pull on the wire because it can damage the leads.
Pull on the plug.
Channel 1 Lead
The shielded red lead with an integrated probe is used for Channel 1 (Figure 9-1). The lead color
matches the color of socket 1 on the Scope Multimeter and of trace 1 on the test screens.
Frequency
40Hz 0.01Hz
±(0.5% of reading + 2 digits) N/A
400Hz 0.1Hz
4kHz 0.001kHz
40kHz 0.01kHz
400kHz 0.1kHz
2MHz 0.001MHz
Duty Cycle 0.1 — 99.9% 0.1% N/A N/A
Pulse Width 0.1 — 99.9% 0.1% N/A N/A
Diode Test 3V* N/A Range = 2V N/A
Continuity 3V* N/A Threshold = 0.1% N/A
Table 9-2 Scope
Function Range Accuracy/Comments
Signal Measurement
Ch. 1—red banana jack
Ch. 2—green banana jack
Each channel input is referenced to
common ground input (GND—black jack)
Sample Rate 20 mega samples per second
Continuous sampling,
MSPS = mega samples per second
Update Rate Real time Real time
Sweep Rate 50 uS to 20 S In a 5 step sequence
Band Width 2 MHz –3 db point
Resolution 8 bit
Coupling AC/DC
Input Impedance 10 MOhm Channel 1 and 2
Table 9-1 Multimeter (sheet 2 of 2)
Function Range Resolution Accuracy
Impedance/
Protection
* Test voltage.
To Next Page
Loading...
