EasyManuals Logo

Snapper 150Z User Manual

Snapper 150Z
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
Operation
General Operating Safety
Before first time operation:
• BesuretoreadallinformationintheSafetyand
Operation sections before attempting to operate this
rider and mower.
• Becomefamiliarwithallofthecontrolsandhowto
stop the unit.
• Driveinanopenareawithoutmowingtobecome
accustomed to driving the unit.
WARNING
If you do not understand how a specific control
functions, or have not yet thoroughly read the
FEATURES AND CONTROLS section, do so now.
Do NOT attempt to operate the rider without first
becoming familiar with the location and function
of ALL controls.
WARNING
Never operate on slopes greater than 17.6
percent (10°) which is a rise of 3-1/2 feet (106 cm)
vertically in 20 feet (607 cm) horizontally.
Select slow ground speed before driving onto
a slope. Use extra caution when operating on
slopes with a rear-mounted grass catcher.
Mow up and down the face of slopes, not across.
Use caution when changing directions and DO
NOT START OR STOP ON A SLOPE.
WARNING
Never allow passengers to ride on the unit.
Before leaving the operator’s position for any
reason, engage the parking brake and disengage
the PTO. Never leave the unit unattended (i.e. out
of sight) with the engine running.
To reduce fire hazard, keep the engine, rider and
mower free of grass, leaves and excess grease.
Do not stop or park rider over dry leaves, grass or
combustible materials.
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the
area. Avoid over-filling and wipe up any spills.
WARNING
Do not load this zero-turn rider on a trailer or
truck using two separate ramps. Only use a
single ramp that is at least one foot wider than
the width of the rear wheels of this rider. This
rider has a zero turning radius and the wheels
could fall off the ramps, or the rider could tip over
injuring the operator or bystanders.
Not for
Reproduction

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snapper 150Z and is the answer not in the manual?

Snapper 150Z Specifications

18.5hp

Engine Specifications IconEngine Specifications
makeBriggs & Stratton
modelProfessional Series
gross horsepower18.5
displacement500cc
Chassis IconChassis
fuel tank capacity3.00 Gallons (11, 4 L)
rear wheels tire size18 x 8.5
rear wheels inflation pressure10-12 psi (, 69-, 83 bar)
front wheels tire size11 x 4
front wheels inflation pressure18-20 psi (1, 24-1, 30 bar)

21hp

Engine Specifications IconEngine Specifications
makeBriggs & Stratton
modelProfessional Series
gross horsepower21
displacement540cc
Chassis IconChassis
fuel tank capacity3.00 Gallons (11, 4 L)
rear wheels tire size18 x 8.5
rear wheels inflation pressure10-12 psi (, 69-, 83 bar)
front wheels tire size11 x 4
front wheels inflation pressure18-20 psi (1, 24-1, 30 bar)

Related product manuals