14
Mower Cutting Height Switch
To increase the mower cutting height (raise the mower
deck), press the top of the yellow cutting height switch.
To decrease mower cutting height (lower the mower
deck), press the bottom of the switch. Mower cutting
height range is approximately 3-3/4” to 1-1/2”. The
cutting height gauge indicates the position of the mower
deck. The cutting height gauge is located on the front of
the rider, just behind the driver’s left leg.
Ignition Switch
The ignition switch starts and stops the engine; it has
three positions:
OFF Stops the engine and shuts off the
electrical system.
RUN Allows the engine to run and powers the
electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN
position with the engine stopped. This drains the battery.
Mower Blade Switch
The yellow mower blade switch turns the mower blades
on and off. To turn the mower blades ON, pull the switch
up. To turn the mower blades OFF, push the switch
down. Always set the engine speed control to FAST
before turning the mower blades ON, and while mowing.
Transmission Release Levers
The transmission release levers deactivate the
transmissions so that the unit can be pushed by hand.
See PUSHING THE UNIT BY HAND for operational
information.
Fuel Tank
To remove the fuel tank cap, turn it counterclockwise.
Features and Controls
To Next Page
Loading...
