Snapper 1650 Series - Page 64

LEVELLING - MID MOUNT MOWERS
Tractor must be on level surface with tires properly
inflated.
1. Place rear gauge wheels in full up position.
2. Place a two inch block under the front edge when
required to raise the front of the mower approx¬
imately 1/4 to 1/2 inch above the rear of mower.
3. Allow mower to rest on gauge wheels.
4. Adjust front lift links so that they will snugly fit in¬
to front anchor plates.
NOTE: Mower should be level or sloping up slightly
at the front when on a flat surface when resting on
gauge wheels in the full up position.