Snapper 1650 - Page 18

Fig. 16 — Transmission Lubrication
1. Dipstick and Fill Point
50 HOURS
STEERING BELLCRANK
Lubricate fitting, Fig. 17, with two shots of multi¬
purpose lithium base grease.
FRONT WHEEL BEARINGS
Lubricate fittings. No. 1, Fig. 18, with two shots of
multi-purpose lithium base grease. In addition to the
fitting shown in Figure 18, there are two fittings on the
spindle and one at the axle pivot point.
Fig. 17 — Steering Bellcrank Lubrication
1. Grease Fitting
Fig. 18 — Front Wheel Lubrication
1. Grease Fitting
300 HOURS OR ANNUALLY
REPLACING TRANSMISSION
AND REAR AXLE OIL
1. Operate Tractor until oil is warm, remove drain
plug. No. 1, Fig. 19, and drain oil.
2. Clean plug and reinstall in transmission hous¬
ing.
3. Refill system with new oil by following pro¬
cedure on Page 16.
Fig. 19 — Transmission Lubrication
1. Drain Plug