Snapper 1650 - Attaching 54 Rear Mount Mower

Fig. 52 — Mower Frame
1. Mower PTO Shield
2. "A" Frame Assembly
ATTACHING 54" MOWER
1. Place gauge wheels in full up position and board
under front edge to level mower front to rear, Fig. 53.
This places mower in level position and front part of
"A" frame in vertical position as viewed from the
side. Fig. 53.
2. Install front portion of PTO shaft onto rear por¬
tion by sliding the two together. Fig. 54.
3. Place Tractor 3-point hitch check chains in rear
hole, Fig. 55.
4. Back Tractor up to within a few inches of mower,
shut off engine and lower Tractor 3-point hitch lift
arms. Fig. 56.
5. Attach lower lift arms to pins on lower mower
"A" frame.
Fig. 64 — PTO Shaft Installation
Fig. 53 — Mower Gauge Wheels
1. Vertical “A" Frame
2. Gauge Wheels
PREPARING 54" MOWER
A CAUTION: To prevent possible injury
do not operate the mower with the de¬
flector chute removed.
The following are required before installing 54"
rear mount mower on Tractor.
3-Point Hitch—Standard on 1650A
Rear PTO—Standard on 1650A
Rear PTO Shield—Optional
1. Install gauge wheels and deflector chute as
shown in Fig. 51, with chute bolt heads down.
2. Assemble "A" frame and mower PTO shield as
shown in Fig. 52.
Fig. 51 — Mower Deflector
1. Gauge Wheels
2. Deflector Chute
3. Deflector Chute Retaining Bolts
— 32