Snapper 1650 - Page 32

Fig. 50 — Mower Drive Belt Installation
1. Mower Drive Clutch Pulley
2. Mower Drive Belt
3. Adjusting Bolt
4. Mule Drive Pulleys
6. Mower Driven Pulley
5. Place mower gauge wheels in full up position.
6. Adjust length of front lift links until the attaching
points line up with the holes in front anchor plate,
see Fig. 47.
7. Remove mule drive cover by removing 2 bolts,
see Fig. 48.
8. Remove mule drive unit by removing 2 spring
clips, see Fig. 49.
9. Place mower drive belt over implement drive
clutch pulley, see Fig. 49.
10. R einstall mule drive.
11. Rotate bolt, No. 6, Fig. 49, counterclockwise
and install belt, No. 2, Fig. 49, under left pulley. No. 7,
Fig. 49, then place belt around mower clutch pulley.
No. 5, Fig. 50.
12. Raise spring loaded pulley, No. 5, Fig. 49, and
install belt under it as shown.
13. Rotate bolt. No. 6, Fig. 49, clockwise until both
mule drive pulleys are the same height.
14. Reinstall mule drive cover.
15. If mower is not level refer to "Levelling", Page
34.
— 31