Snapper 1650 - Page 31

Fig. 46 — Attaching Mower
1. Hanger Strap*
2. Rear Lift Link
3. Anchor Plata*
4. Front Lift Link
5. Yoke
6. Bolt and Hair Pin
7. Retainer Spring
Fig. 47 — Attaching Mower
1. Front Lift Link
Fig. 48 — Attaching Mower
1. Mower Drive Belt
2. Right-Hand Pulley (Mule Drive Unit)
3. Tenaion Spring
4. Mule Drive Cover
5. Adjusting Bolt
ATTACHING 42" & 48" MOWERS TO TRACTOR
NOTE: Mowers can be slid under the Tractor
from either side.
1. Slide mower under Tractor or using mounting
ramp accessory, drive Tractor over mower. See in¬
structions on Page 34 for proper use of mounting
ramps.
2. Start Tractor engine, lower lift arms and then
shut off Tractor engine.
3. Attach rear lift arms to rear anchor plates as
shown in Fig. 46.
4. Attach hanger straps to mower as shown in
Fig. 46.
Fig. 49 — Mower Drive Belt Installation
1. Mower Drive Clutch Pulley
2. Mower Drive Belt
3. Mule Drive Mounting Pins
4. Mule Drive Retaining Clips
5. Right-Hand Pulley
6. Adjusting Bolt
7. Left-Hand Pulley
— 30 —