Snapper 1650 - Attaching Mid-Mount Mowers

Fig. 38 — Hanger Straps Fig. 40 — Rear Lift Link Installation
1. Correct Position of Lift Arms 1. Rear Lift Links
PREPARING MID-MOUNT MOWERS
NOTE: Preparation of the side and rear dis¬
charge mowers is the same except that on rear
discharge models, the deflector chute should
not be installed until after the mower is
positioned under Tractor.
1. Install hanger strap retainer springs on rear of
mower as shown in Figure 39.
2. Install rear lift links on mower as shown in Fi¬
gure 40.
3. Install front lift links on mower as shown in Fi¬
gure 41.
4. Install gauge wheels as shown in Figure 42.
5. After installing mower on Tractor, install side or
rear deflector chute with bolt heads down.
Fig. 41 — Front Lift Link Installation
1. Front Lift Links
CAUTION: To prevent possible injury
do not operate the movker with the
deflector chute removed.
Fig. 39 — Hanger Strap Retainer Springs
1. Retainer Springs
2. Attaching Bolts
3. Belt Covers
Fig. 42 — Gauge Wheel Installation
1. Gauge Wheel and Post
2. Klik Pin
3. Bracket
— 29