Snapper 1650 - Introduction

INTRODUCTION
The Snapper 1650 & 1650A Garden Tractors are equipped with a 16 horsepower, air-cooled, four-cycle
engine and are driven by a hydrostatic transmission in combination with a two-speed rear axle.
PTO driven implements are controlled by an electric clutch, which is driven by engine front PTO shaft.
Mounted implements are raised and lowered by a hydraulic lift. Rear PTO, which is standard on 1650A and
optional on 1650 models, is controlled by a belt idler clutch.
Tractors are equipped with headlights, twin tail lights and electric starter. A variety of front, mid and rear
mounted implements are usable with machine.
This Manual contains two sections regarding care of Tractor. "Maintenance" Section is concerned with
usual servicing procedures, requiring average mechanical ability. "Servicing" Section discusses more com¬
plex procedures, requiring above average mechanical ability and tools. Although all service must be per¬
formed in a competent manner, it is recommended that procedures discussed in "Servicing" Section be
performed by able mechanics, such as those available at Snapper Dealers.
All directions, left or right, are when seated on Tractor seat. READ THIS MANUAL CAREFULLY BEFORE
OPERATING TRACTOR AND ROTARY MOWER. Give special attention to paragraph entitled "Pre-Starting
Inspection."
*
— 4 —