Snapper 1650 - Page 9

make certain transmission, differential and hy¬
draulic system are properly filled with Automatic
Transmission Fluid. For heavy-duty or extreme
temperature service synthetic hydrocarbon oil is re¬
commended.
LUBRICATE FITTINGS
Lubricate grease fittings with a good grade of
lithium base, general purpose grease. See Page 17.
TRANSMISSION CONTROL
AND BRAKE LINKAGE
Check adjustment. See Page 22.
TIGHTEN ALL CHASSIS
BOLTS AND SCREWS
Check chassis bolts carefully. Some are in alu¬
minium housings and if overtightened threads may
be easily damaged.
WHEEL BOLTS (REAR)
Check rear wheel bolts for tightness. See Page 18.
TIRE PRESSURE
ENGINE CYLINDER HEAD BOLTS
Check cylinder head bolts, in order shown.
Fig. 23, to 300 in.-lbs. (30 ft.-lbs.) torque.
DRIVE TEST
Drive Tractor, observing ammeter, controls and
clutch-brake operation. Check operation of all
safety switches in brake, seat and PTO controls.
IS OPERATOR'S MANUAL AND
ASSEMBLY INSTRUCTIONS
WITH TRACTOR?
Make sure Operator's Manual and Assembly
Instructions are with Tractor and explain following
to owner:
Controls
Wheel Tread Adjustments
Operating Procedures
Lubrication
Air Filter Service
Tire and Battery Care
Storage
Operator's Manual
Safety and Caution Notes and Procedures.
Tractors are shipped with tires inflated from 25
to 30 psi. Check tires carefully and bring pressures
to amounts listed on Page 18.