Using the Phone
Using the phone
This section describes the functions of the phone with the factory default settings. If your phone was
installed and/or set up by someone else, the default settings may have been changed. Please check
with that person or company if the phone does not react as described here.
The caller information displayed on the screen is controlled by a setting on the phone‘s web interface.
The default setting is "Name". You can change the setting at Preferences > General Information >
Number Display Style by selecting a different option from the drop-down list.
Making calls
See "Entering numerals, letters, special characters, and symbols" on page 24 for information on input
modes and entering letters, numerals, and special characters.
Selecting identity for current outgoing call
See "Identities/accounts" on page 64 on how to configure identities.
If more than one identity is shown on the display, the one on the dark bar is the outgoing identity for the
call and the number/name that will show on the callee’s phone. Use
or to select another identity.
Using different audio devices
Handset
• Pick up the handset, enter the phone number, and press
. OR
• Enter the phone number and pick up the handset.
Headset
Enter the phone number and press
or headset key. If Bluetooth headset, see also Appendix 6 on
page 92.
Speakerphone
Enter the phone number and press the speaker key.
Handset or headset and casing speaker
1. Use the method for handset or headset use to dial.
2. When the call has been established, press
to allow other persons present in the room to
listen to the party on the other end. Press the key, which has changed to
, again to turn the
speaker off.
http://arttel.ru
http://arttel.ru/shop/ip-telefony/snom-d765
To Next Page
Loading...
