EasyManua.ls Logo

Snorkel S4732E - Override Button and End of Day Procedures

Snorkel S4732E
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 9 – Operation
52 S3215L/S3215E/S3219E/S3220E/S3226E/S4726E/S4732E – 1500834
Override Button
The override button at the upper controls may be used
to override the platform overload and the Snorkel Guard
system, when either one is activated.
When the platform overload system is activated, the
override or the emergency power button (refer to Figure
9.10) at the upper controls may be used to override the
system to operate platform raise/lower functions.
When the Snorkel Guard system is activated, the override
button (refer to Figure 8.2) at the upper controls may be
used to override the system to operate platform raise/lower
functions.
Warning
The potential for an accident increases when safety
devices do not function properly. Death or serious
injury could result from such accidents. The override
switch must only be used when all controls are re-
leased and in the neutral position. If a zero or neutral
state cannot be achieved, depress the emergency
stop and obtain assistance at the lower controls.
1. When the machine is stopped due to activation of
the Snorkel Guard system or overload, immediately
depress the emergency stop, release the joystick
interlock and all controls. Perform an assessment of
the situation which caused the system to activate.
2. If it is determined that all controls are released and
operation can proceed, return the emergency stop
to the on position, and activate the override switch.
3. Activate the joystick interlock.
4. Activate the necessary functions to move the platform
away from the obstacle that caused the Snorkel
Guard activation or if due to an overload fault, lower
the platform in a safe condition.
5. Assess the machine for any damage. If damage
occurred, return to the stowed position, exit the unit
and perform a thorough inspection before returning
to service.
After Use Each Day
1. Ensure that the platform is fully lowered.
2. Park the machine on a rm level surface, preferably
under cover, secure against vandals, children and
unauthorized operation.
3. Turn the controls selector switch to OFF and remove
the key to prevent unauthorized operation.

Table of Contents