Chapter 7 – Prestart Inspection
32 SL30SL – 8210037
Prestart Inspection Checklist
Item Inspect For OK
Operator’s Manual In place, all pages readable and intact
Engine
Oil Level Between full and add marks
Coolant Proper uid level
Radiator Cap tight, good condition and clean
Fuel tank and line Tank full, cap in place and tight/no leaks
Air lter Good condition
Electrical System
Battery Condition and charged for proper operation
Battery terminals Clean, connectors tight
Cables and wiring harness No wear or physical damage
Hydraulic System
Fluid level Between minimum and maximum marks, cap in place and tight
Hoses, tubes and ttings No leaks
Tires
Air lled Good condition, proper ination
Wheels All wheel lug nuts present and properly torqued
Lower Control Station
Operating controls Proper operation
Emergency stop Shuts off lower controls/proper operation
Upper controls emergency stop Proper operation
Emergency Lowering Proper operation
All Motion Alarm Sounds when machine is operated and/or driven
Flashing Light Proper operation
Lowering Alarm Sounds when platform is lowered
Structures
Weldments Welds intact, no damage or deformation
Fasteners In place, tight, and no damage
Upper Control Station
Guardrail system Welds intact, no damage or deformation
Lanyard anchors In place, no damage or deformation
Operating controls Proper operation
Emergency stop Shuts off upper controls/proper operation
Horn Sounds when activated
Placards and Decals In place and readable
To Next Page
Loading...
Need help?
General
