Socket 7 Series - Page 9

SPP MODE
Connect Android device in SPP mode
Note: Socket Scan 10 soft ware inst al l at ion required.
1. Power on t he CHS and scan t his barcode. The CHS will beep 3 t imes.
2. Turn Bluet oot h on for your device. Go t o Set t ings >
Bluet oot h. A Bluet oot h Devices search will begin.
3. Tap Socket CHS[xxxxxx] in t he list of Devices found.
Af t er a f ew seconds t he “ Not Paired” st at us will change
t o “ Connect ed” and t he CHS Blue LED will blink every 3
seconds conrming the connection.
4. Go t o Google Play St ore, search f or “ Socket Scan 10” .
5. Download & inst all. Follow t he on screen inst ruct ions.
6. Open Socket Scan 10 applicat ion.
7. When prompt ed t o set Socket Scan 10 as t he keyboard
language, t ap Back
.
8. Go t o phone Set t ings / Language and Input
9. Under Keyboard Set t ings, select Socket Scan 10.
10. Open Socket Scan 10 on your device.
11. Tap t he Menu
* icon, t hen select Input Met hod.
*
icon may not be visible. Tap where t he menu would normally appear.
12. On t he next screen, select Socket Scan 10 as input met hod.
13. Tap t he “ Set Up Input Met hod” .
14. In Socket Scan 10, t ap t he Menu * icon t hen select Socket EZ Pair.
Note: Select SocketScan 10 to congure the keyboard language or congure
t he but t on t o a scan t rigger but t on
15. Tap t he opt ion “ Bluet oot h” .
16. Tap Socket CHS[xxxxxx]* f rom t he list of devices found.
17. The CHS will beep once t o indicat e connect ed st at e and is ready t o scan
barcodes. Close/ exit applicat ion.
Now you are ready to scan barcodes!
9