Socket CHS Series 7 - Page 105

APPENDIX E: COMMAND BARCODES FOR CHS 7C 105
IMPORTANT! Print out the page to scan the barcodes. Do not scan them onscreen.
Automatic Reconnection Settings
ENABLE Automatic Reconnection from CHS (default)
Configures the CHS to automatically initiate a connection to the last paired computer /
device after the CHS is powered on.
IMPORTANT! After scanning this command barcode, power off and power on the CHS
to make sure it is configured properly.
DISABLE Automatic Reconnection from CHS
Configures the CHS to wait for a computer / device to initiate a Bluetooth connection
after the CHS Is powered on.
IMPORTANT! After scanning this command barcode, power off and power on the CHS
to make sure it is configured properly.
Factory Defaults
Factory Reset
Configures the CHS 7C/7Ci
to revert all settings to factory defaults. The CHS will power
scanning this barcode.
Data Editing – Suffix
Note: These command barcodes are compatible only with Revision B or later of the CHS 7C /7Ci.
Data As Is (Default)
Configures the CHS to
return only the decoded
data (i.e., prefix and
suffix are not sent).
Suffix – Carriage
Return
Configures the CHS to
add a carriage return at
the end of decoded data.
Suffix – Tab
Configures the CHS to
add a tab at the end of
decoded data
Suffix – Carriage
Return & Line Feed
Configures the CHS to
add a carriage return and
line feed at the end of
decoded data.