Socket CHS Series 7 - Page 118

118
TROUBLESHOOTING FOR WINDOWS PC
SYMPTOM: I am using the CHS in SPP mode and get the “CHS not connected” icon in the system tray and
can’t trigger the scanner or scan any barcodes.
POSSIBLE REASON SOLUTION
Your PC is not connected to the CHS.
Make sure the CHS is on, in range and has enough battery
power. Try to reconnect.
SYMPTOM
: When I try to access SocketScan 10, I get an error message saying the installed version of the
application could not be determined.
POSSIBLE REASON
SOLUTION
You installed SocketScan 10 while logged
into a different account.
Log into the account you used while installing SocketScan10.
Alternatively, you can install SocketScan 10 for every user
account that plans to use the CHS.
SYMPTOM
: After I try to connect, SocketScan 10 reports the Friendly Name of the last CHS connected to the
computer, and I cannot modify any advanced settings or symbologies.
POSSIBLE REASONS
SOLUTION
This is a known issue in SocketScan 10 for
Windows XP and Vista.
Close and restart SocketScan 10 and reconnect.
SYMPTOM
: The Bluetooth software indicates that the CHS has connected, but when I try to scan data, it does
not enter into my application.
POSSIBLE REASONS
SOLUTION
The CHS is in SPP mode, and your PC has
multiple incoming Bluetooth serial ports
enabled.
Use your Bluetooth utility to disable extra incoming Bluetooth
serial ports. In SocketScan Settings, click Ports to acce
ss the
Bluetooth utility.
The CHS is in SPP mode, and SocketScan
10 Is not running.
Start SocketScan 10. Click on the desktop shortcut icon.
The keyboard wedge is not enabled in
SocketScan Settings.
Make sure Use keyboard wedge is selected.
The CHS is in SPP mode but not assigned to
an incoming Bluetooth serial COM port.
In SocketScan Settings, make sure the CHS is assigned to
an incoming Bluetooth serial COM port. If your computer has
the Toshiba Bluetooth stack, in SocketScan Settings, click
Ports. Make sure the CHS is assigned to a Bluetooth port
named LocalCOM-Server.
SYMPTOM
: The SocketScan 10 system tray icon does not appear by default after I install the software.
POSSIBLE REASONS
SOLUTION
Bluetooth was not fully initialized before
launching SocketScan 10.
Make sure Bluetooth is enabled. Open SocketScan 10
Settings by navigating to: Your local drive:\Program
Files\Socket Mobile\SocketScan 10\Bin\Windows. Click
on SocketScan Settings.exe. Make sure Use keyboard
wedge and Show keyboard wedge icon in task tray are
selected and click OK.
SYMPTOM
: After the CHS connects, an error message says the application failed to initialize properly.
POSSIBLE REASONS
SOLUTION
Your system is missing .NET Framework (0xc0
Install the latest version of .NET Framework with the
appropriate version of Runtime software.