60
To scan barcodes:
1. In your application, place the cursor where you want to enter data.
2. Hold the CHS about 4 inches (10 cm) from the barcode and press and hold the trigger button.
An aiming beam will appear for 3 seconds. Keep your hand steady while scanning.
For example, try scanning the following barcode:
After data is read and sent to the Apple device, by default, the CHS will beep once and
vibrate, the LED will flash green, and the beam will turn off.
If no data is read in a few seconds, the beam will turn off, and you must try again.
Watch a video: http://www.youtube.com/user/socketmobile#p/a/u/0/eZqb99pAbEc
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds, until
the CHS beeps twice (high-low) and the blue LED turns off.
After the iPad disconnects from the CHS, the soft keyboard will automatically reappear
within a few seconds.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last computer it paired
and connected to. Make sure your computer is in range with Bluetooth enabled.
If the CHS is connected to your computer and gets disconnected, it will try to reconnect for
45 seconds. Make sure the computer is on and in range. If the CHS cannot reconnect after
several attempts, it will emit a long beep. Power cycle the scanner to restart the reconnection
process.
The CHS can only be paired with one device at a time. To use the CHS with a
different device, see Appendix G
for unpairing instructions.
To Next Page
Loading...
