CHAPTER 5: SETUP FOR APPLE 59
1. Power on the CHS. Press and hold the small power button until the LED turns blue
and the CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is on but
not connected.
2. Open the CHS 7Ci compatible application that you installed.
3. Enable Bluetooth on the Apple device. A Bluetooth device search will begin.
4. In the list of found devices, select iOS Socket 7Ci. If prompted, tap Pair.
In the device search, the CHS will appear as Socket CHS[xxxxxx]. The characters
in brackets are the last six characters of the CHS Bluetooth Device Address
(BDA), which is labeled inside the battery compartment.
The CHS will beep once after it has connected and is ready to scan barcodes.
The LED will also blink blue once every 3 seconds.
To Next Page
Loading...
