-61-
Phase colors
Measuring results belonging to different phases are presented with individual colors.
The default colors are yellow for phase A (L1), green for phase B (L2), red for C (L3),
and gray for N (neutral).
Screen types
1. Table screen: gives an instantaneous overview of important numerical
measuring values.
2. Trend screen: this type of screen is related to a table screen. Trend
screen shows the course over time of measuring values from the table.
3. Waveform screen: shows voltage and current waveforms as displayed
on an oscilloscope. Channel A (L1) is reference channel.
4. Phasor screen: shows the phase relation between voltages and currents
in a vector diagram. The vector of reference channel A (L1) points to the
positive horizontal direction.
5. Bar Graph screen: shows the density of each measuring parameters as
a percentage by means of a Bar Graph.
Screen information common for all screen types
a. Measuring mode: the active measuring mode is shown in the screen
header.
b. Measuring values: main numerical measuring values. If cursor is off, the
newest values are shown; otherwise, the values at the cursor are
shown.
c. Status indicators: Display working states of battery or adapter, and time
that a measurement has been going on.
d. Main area with measuring data.
To Next Page
Loading...
