ATySp - Annexe II
123
EN
M-G M-M
Note: This input function together with the associated time delays
(E1T, E2T, E3T) are particularly useful for peak shaving.
y
These inputs allow to initiate the transfer from one source to the other
y
Note: These alarms do not trigger any position change in the
switch but the product not available output will be activated.
y
Note: Immediately upon activation of one of these inputs the
time delay will not be considered.
y
This input may be used to reset a fault condition after the fault has
shifting the front selector switch on the ATy
To Next Page
Loading...
