socomec DIRIS Digiware D-50 - Display-Specific Settings

18 EN
DIRIS Digiware D-50 & D-70 - 548088B - SOCOMEC
The 3 following menus will be detailed in the paragraphs below:
PARAMETERS
|
DISPLAY
CONFIGURE A DEVICE
AUTODETECT SERIAL DEVICES
LIST PRODUCTS
ADD NEW DEVICE
…
• DISPLAY: to access settings that are specic to the display.
• AUTODETECT SERIAL DEVICES: to launch an automatic detection and addressing of meters and power monitoring
devices connected to the D-50/D-70 display.
• CONFIGURE A DEVICE: to congure the meters and other power monitoring devices connected to theD-50/D-70
display.
8.1. Display-specic settings
PARAMETERS
|
DISPLAY
CONFIGURE A DEVICE
AUTODETECT SERIAL DEVICES
LIST PRODUCTS
ADD NEW DEVICE
…
DISP PARAMETERS
|
LANGUAGE
DATE FORMAT
RS485 COMMUNICATION
ETHERNET COMMUNICATION
SET REMOTE DEVICE DATE/TIME
…
• LANGUAGE: to set the display's navigation language (english by default)
• DATE FORMAT: to set the date/time format
• RS485 COMMUNICATION: to congure the RS485 communication settings
• ETHERNET COMMUNICATION: to set the display's IP address
• SET REMOTE DEVICE DATE/TIME: to set the date and time
• CHANGE PASSWORD: to change the password to access the settings menu (default: "100")