Why my Socomec UPS is showing PFC Over Heat Shutdown?
If your Socomec UPS experiences a PFC Over Heat Shutdown, it may be due to blocked vents or an internal fault. Start by checking the vents to ensure they are not blocked. If the problem continues, contact service personnel.
What to do if my socomec NETYS RT UPS displays DC Bus Over Shutdown?
If your Socomec UPS displays a DC Bus Over Shutdown, it could be due to capacitive or inductive loads or an internal fault. First, try removing any capacitive or inductive loads. If the issue persists, contact service personnel.
What to do if my socomec NETYS RT UPS is in "Battery Mode" even with mains connected?
If your Socomec UPS is running in battery mode despite a healthy mains connection, it could be due to several reasons: * The input voltage may not be registering at the UPS input. Check the input voltage connection. * The thermal-magnetic switch on the rear panel might have tripped. Reduce the load and reset the switch. * The input voltage could be too high, too low, or distorted. In this case, have the mains voltage checked by a qualified electrician.
General| Technology | On-Line Double Conversion |
|---|---|
| Frequency | 50/60 Hz |
| Battery Type | Sealed Lead-Acid (SLA) |
| Communication Ports | USB, RS232 |
| Waveform | Sinewave |
| Operating Temperature | 0 to +40 °C |
To Next Page
