BTS E5~20-DS5 user manualV1.1
Copyright © Shenzhen SOFARSOLAR Co., Ltd
perform the following steps to check whether the current
installation status meets the battery operating requirements:
Is the battery installed in a clean, dry, well-ventilated
location？
Check whether the battery DC switch is off？
Check whether the cable section and length meet
requirements？
Is the wiring good？
Whether the configuration Settings are correct for the
user's specific installation？
Whether the communication cable is correctly
connected and is not damaged？
6.2.
Daily Maintenance
After the battery is powered off for 5 minutes, ensure
that the capacitor inside the battery is discharged before
maintenance.
Batteries usually do not require maintenance or calibration, but ensure
that the radiator is not covered with dust, dirt, etc.
1) Clean the battery module
Please clean the battery module with an air blower, a dry & soft cloth or a
soft bristle brush. Do not clean the inverter with water, corrosive
chemicals, detergent, etc.
2) Clean the heat sink
In order to ensure the normal function and long service life of the product,
it is necessary to ensure that there is enough air flow space around the
radiator at the rear of the product, and there is no material around the
radiator that obstructs the air flow, such as dust or snow, must be
removed. Clean the heat sink with compressed air, a soft cloth, or a soft
brush. Do not use water, corrosive chemicals, cleaning agents, or strong
To Next Page
Loading...
Need help?
General
