ELECTRICAL CONNECTIONS
52 HYD 5K...20KTL-3PH
Removing the connectors
Danger of DC arcing
• Before removing the plus and minus connector, ensure that
the DC switch has been set to OFF.
In order to remove the plus and minus connection from the inverter,
insert a removal key into the locking and press on the key with the
adequate force as shown in the following illustration:
5.7 Connecting the AC power cables
The AC power cables are used to connect the inverter to the critical
loads (through the EPS port), and the AC power distributor or the
power grid.
AC connection
• Each inverter must have its own circuit breaker.
• The AC disconnecting device must be easily accessible.
To Next Page
Loading...
