Sofarsolar HYD 3K-6K-EP - Performance Monitoring

HYD 3K~6K-EP User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd。
- 46 -
1．Parallel Control: Enable or disable parallel functions. Both the master and
the slave must enable this function.
2．Parallel Primary-Replica: Set up the Primary and Replica.Select one
inverter as the Primary and set the others to Replica.
3．Parallel Address: Set the parallel address.Each inverter needs to set a
parallel address, and the parallel address in a parallel system cannot be repeated.
（NOTE:The parallel address is different from the communication address used for
monitoring.）
4．Save: Save after the setup is complete.
7. Bluetooth Reset
7.Bluetooth Reset
OK
Please confirm!
OK
Success
8. CT Calibration
To calibrate the direction and phase of the CT, the battery should be charged
or discharged when using this function.
8.CT Calibration
OK
Calibrating
Sucess/Fault
Check if the battery is charging or discharging when calibration fails。
6.3.3 Energy Statistic
3.Energy Statistic
OK
Today
PV ............................***KWH
Load .........................***KWH
Export ......................***KWH
Import.......................***KWH
Charge.......................***KWH
Discharge..................***KWH
Down↓
Month
PV ............................***KWH
Load .........................***KWH
Export ......................***KWH
Import.......................***KWH
Charge.......................***KWH
Discharge..................***KWH
Down↓
Year
PV ............................***KWH
Load .........................***KWH
Export ......................***KWH