SOFAR 60-80KTLX-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd.
the setting of the phase shift factor. Feed-in management can be controlled directly
by the APP, or through a RS485 interface.(Optional)
C. Limited the active power fed into grid
If enable the limited of active power function, inverter can limit the amount of
active power fed into the grid to the desired value (expressed as percentage).
D. Self-power reduction when grid is over frequency
If grid frequency is higher than the limited value, inverter will reduce the output
power to ensure the grid stability.
E. Data transmission
Inverter can be monitored remotely through an USB stick logger(WIFI) or software
Storage Monitor(optional) which is based on RS485 interface.
F. Software update
USB interface for uploading the firmware, remotely uploading is available through
an USB stick logger(WIFI)
2.3. Electrical block diagram
SOFAR 60~80KTLX-G3 has 12 DC input strings, 6 MPPT trackers to tracking the
maximum power point, then converters the direct current of PV array to
grid-compliant, three phase current and feeds in into the utility grid. Both DC and
AC side has Surge Protection Device (SPD).
To Next Page
Loading...
