ANSI/NEMA FL1 Chart
Specifications
Emitter: 1 x SST40 LED with a lifespan of up to 50,000 hours
Battery: 18650 battery
Operating voltage: 2.7 V - 4.2 V
Dimension: 111 mm (length) × 26 mm (head diameter) x 25 mm (body diameter)
Weight: 65 grams (without battery, without headstrap)
Headlamp body: Aerospace grade 6061 grade aluminum alloy, CNC manufactured to hard-anodized to
military grade specification type III, anti-abrasive finish to get solid built body, anti-crash geometry and
better heat exchange.
Toughened mineral glass lens - scratch and wear resistant
Automatic Stepdown: Turbo mode steps down to High mode automatically to prevent overheating.
Circuit Protection
It’s protected from improper battery installation.
When it’s too hot at Turbo or high mode, it automatically steps down to lower mode to prevent
overheating.
It automatically steps down to lower modes when the 18650 battery does not have enough power.
It turns off when voltage is lower than 2.7V. Please replace or recharge the battery as soon as
possible.
Low power indicator: theheadlamp tellsbattery status, ifbattery doesn’t have enough power,headlamp stayson
lowermod
Battery Specification
Battery Installation: Unscrew the tailcap to
insert one 18650 battery with the
anode side (+) towards the head, then screw
the tailcap back on.
depending on ramping level
IP68 (up to 2 meter under water, not for diving)
USB-C port, input DC 5V 2A
The above mentioned parameters are based on tests according to international
flashlight testing standards (ANSI/NEMA FL1) using one 3000mAh 18650 Li-ion
battery in our laboratory. Results may vary with different batteries or under
different environmental conditions.
Rechargeable lithium-ion battery