D. One LED indicator always on: 3% ≤ battery power <25%.
E. One LED indicator flashing: 0% < battery power <3%.
Charging indicators (LT1S Pro accepts 5V and 3A max charging current, use your phone charger
and the provided USB-A to USB-C cable):
A. Four LED indicators always on: battery power = 100% (fully charged).
B. Three LED indicators always on, one LED indicator flashing: 75% ≤ battery power.
C. Two LED indicators always on, one LED indicator flashing: 50% ≤ battery power <75%.
D. One LED indicator always on, one LED indicator flashing: 25% ≤ battery power <50%.
E. One LED indicator flashing: battery power <25%.
Reverse charging: The four LED indicators gradually turn off one by one as the battery power is
depleted. The device can be used as a portable charger for charging your phone. A separate C-C
cable or C-lightning cable is required for charging, and neither of these cables is included in the
package.
Operation Instructions
By default, the light uses a simple UI. This is useful if you lend the light to someone else. Simple
UI has all the basic functions needed to work as a light, but the minimum and maximum
brightness are limited to make it safer, and any complex or advanced functions are blocked.
ON/OFF: Single-click the switch to turn on/off the light.
TURBO: When the light is on/off, double-click the switch to enter Turbo.
CHANGE CHANNEL MODES: triple-click the switch to change channel modes. warm/cool
white blend-auto 2ch white blend (warm → cool by ramp level)-auto 3ch blend (red → warm →
cool by ramp level)-red only-red + white blend
CHANGE BRIGHTNESS: When the light is off, press and hold the switch and it will start from
Eco, and automatically cycle through Eco, Low, Medium, High, and Turbo, or increase its
brightness steplessly.
CHANGE BRIGHTNESS: When the light is on, press and hold the switch and it will start from
the present brightness level, and automatically cycle through Eco, Low, Medium, High, and Turbo,
or change brightness steplessly. The direction of the increases/decreases may be changed by
repeating the aforementioned process within 1.5 seconds. Wait longer than 1.5 seconds (on the
second press) to continue in the direction of change (rather than reverse it).
LOCK MODE: When the light is off, quickly click the switch 4 times, and the lantern flashes
once to signal the lantern is locked. In the lock mode, press and hold the switch to activate the
momentary low, and release the switch to turn off the light. click the switch 4 times again to
To Next Page
Loading...
