Sofirn LT1S Pro - Advanced Operation Modes; Voltage Checking; Strobe Mode Access; Ramping Mode Toggle

disable lock mode.
VOLTAGE CHECKING: When the light is off, quickly click the switch 3 times to check the
battery voltage; Click the switch once to exit the voltage checking mode.
STROBE: When the light is off, quickly click the switch 3 times and hold the last click to enter
Strobe mode. To change to the next blink use a double-click.
TOGGLE BETWEEN SMOOTH RAMPING AND STEPPED RAMPING: When the light is
on, 6 clicks on the switch to toggle between smooth ramping and stepped ramping.
CHANGE THE BRIGHTNESS OF THE SWITCH LED INDICATOR: When the flashlight is
off, 7 clicks on the switch to change the brightness of the button led indicator.
(low-high-blinking-off)
ADVANCED UI: quickly click the switch 10 times and hold the last click to switch to Advanced
UI.
Advanced UI
Button presses
Button presses are abbreviated using a simple notation:
- 1C: One click. Press and then quickly release the button.
- 1H: Hold. Press the button, but keep holding it.
- 2C: Two clicks. Press and release quickly, twice.
- 2H: Click, hold. Click two times, but hold the second press.
- 3C: Three clicks. Press and release quickly, three times.
- 3H: Click, click, hold. Click three times, but hold the final press.
The same pattern is used with higher numbers too. For example, 10C means ten clicks... and
10H means ten clicks but hold the final press.