Simulates a flickering candle or fireplace, until you switch it OFF. Or you add timer for 30min:
Each triple click adds 30 min including a burn down simulation at the end. Candle mode timer can
go for up to 4.5 hour.
Bike flasher:
Steady output with a “stutter” once per second. Designed to be more visible than a normal
ramping mode, but otherwise works mostly the same. Adjustable brightness.
Party strobe:
Motion-freezing strobe. Can be used to freeze spinning fans and falling water. Adjustable speed.
Tactical strobe:
Bright, disorienting strobe light. Can be used to irritate people. Adjustable speed, and the duty
cycle is always 33%.
Lightning storm mode:
Flashes at random brightness and random speed to simulate lightning strikes during a busy
lightning storm. Do not look directly at the light when this mode is running, because it may
suddenly go to full power without warning.
Safety Instructions
LT1S Pro is a powerful lantern. Never point it directly at a person, animal or moving vehicles.
Doing so could cause retinal damage. Please do not allow children to play with it. Strobe
mode may cause seizure in persons with photosensitive epilepsy.
Operating LT1S Pro for a long time in high-powered modes will quickly heat up the light.
This is normal.
Pay close attention to the proper installation of the battery. Always check that the positive end
of the battery faces its head before screwing the tail cap back on.
Please unscrew the tail cap half a turn to avoid unwanted activation during transport. It also
prevents the battery from draining while the light is in standby.
Avoid hitting or dropping the light.
Troubleshooting and Maintenance
Disassembling the sealed head can damage the light and voids the warranty.
Sofirn, Ltd. recommends using high-quality brand batteries. Damage by battery leakage voids
the warranty.
Remove the battery if the light will not be used for an extended period of time.
To prevent self-discharge or accidental activation during storage or transportation, unscrew
the tailcap by half a turn or remove the battery.
Every 6 months threads should be wiped with a clean cloth followed by a thin layer of
silicone grease.
To maintain a proper level of waterproofness, replace worn-out o-rings with an approved
spare.
Troubleshooting: Clean battery contacts regularly as dirty contacts may impair the
performance of the light. If you experience problems (flicker, shine intermittently or failure
turn on) the following root causes and solutions should be tried:
To Next Page
Loading...
